33 Chapter 3: Nav Station Setup
To select a different color palette
1. On the power control toolbar, press MONITOR CONTROLS.
2. Toggle to the palette you want to use on the PALETTE softkey.
3. Press OK.
3.3 Keyboard settings
When a system is commissioned, settings are made which associ-
ate keyboards with Nav Stations and displays. This allows you to
use one keyboard to control different Nav Stations or monitors (but
only one at a time).
To use the keyboard at a different monitor
1. Press the left/right arrows on the keyboard to select the name
of the display you want to use.
To use the keyboard at a different Nav Station
1. Press the up/down arrows on the keyboard to select the name
of the Nav Station at which you want to use keyboard.
3.4 Setting language, date and time,
and units of measurement
All these settings are configured from the system Setup menu.
To configure language, units, date and time format
1. Open the system Setup Menu.
2. Select the settings you want to configure.
3. Make the appropriate changes.
4. Press OK.
Note: For information about to change menu settings, see Setup
menus on page 23.
3.5 Local settings
The majority of functions, settings, and changes that you make on
a Nav Station are detected by all the Nav Stations in the system.
There are, however, some local settings that affect only the monitor
on which you are working (and its repeater if there is one).
These local settings are:
• Page set: selecting a set, name and applications configuration.
• The active window.
• The displayed panel in the digital data or engine monitoring
application.
• Radar and Fishfinder presentation settings.
• Radar VRM, EBL and wakes.
• Chart presentation settings when chart view is set to local.
• Show/hide waypoints, routes and tracks.
• Display Setup Menus.
• Databar on/off and configuration.
• Chart ruler settings.
To Next Page
Loading...
