79 Chapter 6: 3D Chart
2. Toggle to the setting you want to adjust.
3. Make the adjustment with the rotary controller.
4. Press OK.
Note: The rotary controller is always active to adjust pitch and
rotation. This is different to most other uses of the rotary
controller, which require you to press a softkey to enable
adjustment.
To set the adjustment reference point
1. Press the ADJUST ON softkey.
2. Toggle to EYE or CENTER as required.
3. Press OK.
Navigation options
Shortcuts to the Route List and Waypoint List are available under
the GOTO softkey. For information about using them, see
page 50.
Routes and waypoints can only be edited from within the standard
chart application, but changes made on the standard chart are
reflected on the 3D chart.
D8258_2
To Next Page
Loading...
