Raymarine i60 - Mounting

5.1Mounting
Pre-mountingcheck
Theproductisdesignedtobesurfacemounted.
Beforemountingtheunit,ensureyouhave:
•Selectedasuitablelocation.
•Identiedthecableconnectionsandroutethatthe
cableswilltake.
•Detachedthefrontbezel.
•Removethekeypadmat.
Mountingdiagram
Mountinginstructions
1.Checktheselectedlocationfortheunit,aclear,
atareawithsuitableclearancebehindthepanel
isrequired.
2.Fixthemountingtemplatesuppliedwiththe
product,totheselectedlocation,usingmasking
orselfadhesivetape.
3.Ifpossibleuseanappropriatesizeholecutterand
cutoutthecentreholecutoutareaasindicated
onthemountingtemplate,or
4.Usingasuitabledrillbit,makepilotholesineach
cornerofthecutoutareaandusingajigsawcut
alongtheinsideedgeofthecutoutline.
5.Ensurethattheunittsintotheremovedarea
andthenlearoundthecutedgeuntilsmooth.
6.Drillanyrequiredholesasindicatedonthe
mountingtemplateforthemountingxings.
7.Peelthebackingoffofthesuppliedgasketand
placetheadhesivesideofthegasketontothe
displayunitandpressrmlyontotheange.
8.Connecttherelevantcablestotheunit.
9.Slidetheunitintoplaceandsecureusingthe
xingsprovided.
10.Fitkeypadmatandfrontbezel.
Note:Drill,tapsizeandtighteningtorquesare
dependantuponthematerialtypeandthickness
ofthemountingsurface.
Note:Thesuppliedgasketprovidesaseal
betweentheunitandasuitablyatandstiff
mountingsurfaceorbinnacle.Thegasketshould
beusedinallinstallations.Itmayalsobe
necessarytouseamarine-gradesealantifthe
mountingsurfaceorbinnacleisnotentirelyatand
stifforhasaroughsurfacenish.
30