Raymarine i70 - Depth and Speed Calibration Procedures

3.
1Toolsrequired
Thefollowingtoolsarerequiredtoinstallyourproduct.
1.P owerdrill
2.92mm(35/8in)Holecutter
3.Adhesivetape
4.Drillbitofappropriatesizeformountingfixings
(1)
5.Pozidrivescrewdriver
6.Plasticprytool
7.File
Note:
(1)Drillbitsizeisdependentonthethicknessandtypeofmaterialthattheproductistobe
mountedon.
3.2Selectingalocation
W arningsandcautions
Important:Beforeproceeding,ensurethatyouhavereadandunderstoodthewarningsand
cautionsprovidedintheChapter1Importantinformationsectionofthisdocument.
EMCinstallationguidelines
R aymarineequipmentandaccessoriesconformtotheappropriateElectromagneticCompatibility
(EMC)regulations,tominimizeelectromagneticinterferencebetweenequipmentandminimizethe
effectsuchinterferencecouldhaveontheperformanceofyoursystem
CorrectinstallationisrequiredtoensurethatEMCperformanceisnotcompromised.
Note:Inareasofe xtremeEMCinterference,someslightinterferencemaybenoticedonthe
product.Wherethisoccurstheproductandthesourceoftheinterferenceshouldbeseparated
byagreaterdistance.
ForoptimumEMCperformancewerecommendthatwhereverpossible:
•R aymarineequipmentandcablesconnectedtoitare:
–Atleast1m(3.3ft)fromanyequipmenttransmittingorcablescarryingradiosignalse.g.VHF
radios,cablesandantennas.InthecaseofSSBradios,thedistanceshouldbeincreasedto2
m(6.6ft).
–Morethan2m(6.6ft)fromthepathofaradarbeam.Aradarbeamcannormallybeassumedto
spread20degreesaboveandbelowtheradiatingelement.
24