Raymarine i70 - Page 27

1.Checktheselectedlocationfortheunit.Aclear ,flatareawithsuitableclearancebehindthe
panel,isrequired.
2.Fixtheappropriatecuttingtemplatesuppliedwiththeproduct,totheselectedlocation,using
maskingorself-adhesivetape.
3.Usingasuitableholesaw,makeapilotholesineachcornerofthecut-outarea.
4.Usingasuitablesaw,cutalongtheinsideedgeofthecut-outline.
5.Ensurethattheunitfitsintotheremovedareaandthenfilearoundthecutedgeuntilsmooth.
6.Drillfourholesasindicatedonthetemplatetoacceptthesecuringscrews.
7.Peelthebackingoffofthegasket,andplacetheadhesivesideofthegasketontothedisplay
unitandpressfirmlyontotheflange.
8.Connectcablestotheunit.
9.Slidetheunitintoplaceandsecureusingscrewsprovided.
Note:Drill,andtapsizeandtighteningtorqueisdependentonthematerialtypeandthickness
theunitistobemountedon.
Installation
27