Note:
Unless manual selection is required for a specific reason, it is recommended that
Manual selection
remains disabled, so that the display can determine the best source for the data.
4.9 Pairing a Quantum™ radar scanner
You can connect a Quantum™ radar scanner to your display using the Wi-Fi connection.
Pre-requisites:
• Ensure you have installed and connected your Quantum™ radar scanner to a power supply
following the instructions supplied with the radar scanner.
• Ensure you know your Quantum™ radar scanner’s SSID and passcode.
1. Select Pair with Quantum from the This display tab: Homescreen > Settings > This display >
Quantum Radar: > Pair with Quantum.
2. Enter the SSID and passcode for your Quantum™ radar.
3. Select
Connect.
4. Follow any onscreen instructions to continue pairing with your Quantum™ radar.
The pairing process may take several minutes to complete.
For more information on the Quantum™ radar pairing process (including troubleshooting
information), refer to your Quantum™ radar documentation.
Set up
41
To Next Page
Loading...
