Installing the socket
1. Apply the template (supplied at the rear of this handbook) to the
bulkhead.
2. Carefully drill a 18 mm (
23
/
32
in) clearance hole and two 2.5 mm
(
3
/
32
in) pilot holes. Remove the template.
3. Pass the cable through the bulkhead and attach to the socket,
making sure you connect each core to the correct pin, as
described in the "ACU (control unit) connection" section.
4. Attach the socket to the bulkhead using the two self-tapping
screws. Use cable clamps to secure the drive cable at regular
intervals.
81131_8.book Page 60 Thursday, October 7, 2004 11:03 AM
To Next Page
Loading...
