2.3 PLANNING THE INSTALLATION
When planning the installation for your RAY210, the following conditions
should be considered to insure dependable and trouble-free operation.
1) The mounting location should be easily accessible to allow operation of the
front panel.
2) There should be adequate ventilation.
3) A sufficient space should be secured behind the transceiver to allow cable
connections to the rear panel connectors.
4) The transceiver should be located near a power source.
5) The selected location should be far enough away from devices that may cause
interference, such as motors and generators.
6) Generally speaking, the transceiver should be protected from prolonged direct
exposure to rain and salt spray. It is a good practice to protect your valuable
electronic equipment as much as possible.
The RAY210 can be conveniently mounted on a chart table, bulkhead, overhead
or any other desired location.
( Table top mount) (Bulkhead mount) (Overhead mount)
Figure 2-1 Typical Mounting Methods
To Next Page
Loading...
