3-65
Operations
Flashing
Flashing
Flashing
ENT
ENT
Input MMSI number
using numeric keypad
ENT
ENT
ENT
re-enter
MMSI No.
ENT
ENT
3.5.30.4.3 Siren Set Up3.5.30.4.3 Siren Set Up
3.5.30.4.3 Siren Set Up3.5.30.4.3 Siren Set Up
3.5.30.4.3 Siren Set Up
This operation changes the tone of the siren that sounds from the Hailer
Horn speaker when the SIREN option is selected in Fog/Siren mode, as
described in Section 3.5.18.
To select the siren tone:
1) Select the SIREN function as described above in Section 3.5.30.4 Setting
Operation (RAY230).
2) Press the ENT key. The 7-segment display shows Sir, the dot matrix
display indicates CODENC1, and the corresponding call tone sounds
from the handset.
3) To change the tone, press the SQ UP/DOWN key to alternate between
CODENC2, CODENC3, and CODENC4. As you scroll, the corresponding
siren tone sounds from the handset. The table that follows describes
the type of tone emitted and the procedure for sounding the siren
while in Fog/Siren mode. Mn is shown on the 7-segment display and
NAVSTAT appears on the dot matrix display.
To Next Page
Loading...
