Chapter 2: Using the RayPilot 650 17
2 Using the RayPilot 650
Course change knob
• Adjusts locked heading
• Adjusts heading in Compass Correction mode
• Moves rudder in Power Steer mode
• Adjusts values in Calibration mode
Watch alarm
The RayPilot 650 has a built in Watch Alarm. This is a timer that
flashes after 3 minutes and sounds an alarm on each control unit a
minute later. To silence the alarm and reset the watch alarm to
4 minutes, press a key or rotate the course change knob.
Note: Watch alarm is not available in Standby or Power Steer modes.
To enable/disable the watch alarm press
LIGHTS and RESP together
momentarily.
D863-1
D1007-1
81013_4.book Page 17 Wednesday, July 25, 2001 11:04 AM
To Next Page
Loading...
