Raymarine SL70M - 2.3 Controlling the Display; Selecting a Half-Screen Window for Display

Chapter 2: Getting Started & Adjusting the Display 2-7
Controlling the
Display
2.3 Controlling the Display
You control the display using the cursor and control keys. You start all
operations from the default screen, that is the default soft keys are displayed:
When you have completed an action using the soft keys, press ENTER or
CLEAR to return to the default screen; you may need to press ENTER or
CLEAR several times to back-track through the soft key hierarchy.
Note: If you have set up your system so that the default soft keys are not dis-
played all the time, press any soft key to display the labels.
The remainder of this section describes how to select the mode of operation
and switch half-screen windows on/off. The following sections describe how
to set up the display for the Radar.
The controls are summarized in the fold-out illustration on page 2.9.
Selecting a Half-Screen Window for Display
➤ To select a window for display:
1. Press the
DISPLAY key. The following soft are displayed with an image of
each available window:
SL70M Mono Display:
SL70C Color Display:
2. To select a different window, press either SELECT WINDOWS soft key until
the required window is highlighted. If necessary, this will toggle windows
on. Press
ENTER.
3. To toggle windows off, press the
WINDOWS OFF ON soft key.
Figure 2-4 shows the half-screen horizontal windows.
Returning to the Full-Screen Display
To return to the full-screen display you can turn windows off, as previously
described. Alternatively, to return to full-screen display:
Press and hold the
DISPLAY key for 2 seconds to return to the currently
selected full-screen (upper window) display
TARGETS SCREENHDG MODE
D4152-3
MARPA
DISPLAY
D4156-3
SELECT
WINDOWS
WINDOWS
OFF ON
ZOOM
OFF ON
DISPLAY
D4208-2
SELECT
WINDOWS
WINDOWS
OFF ON
ZOOM...
DISPLAY