34
To connect SeaTalk cabling
WARNING: Use correct fuse
The fuse supplying the SeaTalk system MUST be rated at 5A or less.
SPX SmartPilot
• Connect SeaTalk cable to SEATALK terminal.
• Connect the other end of the SeaTalk cable to a 3-way terminal block or other
suitable connector on the system.
Note:
If you are supplying power separately to the SeaTalk bus, do NOT connect the red wire at
the SPX SmartPilot.
Course computer
MADE IN HUNGARY
Raymarine Limited
POWER, 15 AMP
12V
OFF
ON
24V
FLUXGATE
RUDDER
CLUTCH
FAULT
SLEEP
FAULT
, 2 AMP, 2 AMP
NMEA
POWER
P
D10459-1
SeaTalk cable
Yellow
Screen
Red
87072-2.book Page 34 Thursday, November 22, 2007 8:43 AM
To Next Page
Loading...
