Chapter 3: Installation 35
Autopilot controller
• Connect the controller to an existing instrument or a connector block. (For detailed
information refer to your autopilot controller installation guide)
Connecting a SeaTalk controller
Note:
If the controller is to be the primary controller, we recommend a direct connection to the
system rather than daisy-chaining the controller to an instrument bus.
Autopilot controller Autopilot controller
ST60+ instrument
D10517-1
SeaTalk cableSeaTalk cable
SeaTalk cable
SeaTalk
cable
SeaTalk 3 way block
SeaTalk cable
ST60+ instrument
87072-2.book Page 35 Thursday, November 22, 2007 8:43 AM
To Next Page
Loading...
