Raymarine SPX 10

To Next Page

To Previous Page

To connect NMEA equipment

CAUTION: Connections to other equipment

If you are connecting Raymarine equipment to other equipment using a non-

Raymarine cable, you MUST attach an appropriate suppression ferrite to the cable

near to the Raymarine unit.

Note:

If you are connecting third party equipment, refer to the manufacturer’s instructions for

installation and cable details. You must not connect more than one piece of equipment to each

SPX computer NMEA input.

You may do any of the following:

• Use the SPX computer NMEA input / output

• Use the SeaTalk / NMEA interface (part number: E85001) to convert the NMEA

data to SeaTalk data.

Connecting NMEA equipment

FAULT

NMEA

equipment

e.g. GPS

NMEA

equipment

e.g. radar, VHF

NMEA

Course computer

D10460-1

87072-2.book Page 36 Thursday, November 22, 2007 8:43 AM

Raymarine SPX 10 - Page 44