8 ST1000 Plus & ST2000 Plus Tiller Pilots
2.2 Using Auto mode
Engaging the autopilot (Auto mode)
1. Steady the boat on the required heading.
2. Place the pushrod over the tiller pin. If necessary, extend or retract the push-
rod using the
-1, +1, -10, and +10 keys.
3. Press
auto: the tiller pilot will enter Auto mode and the display will show an
‘A’ (for auto) alongside the locked autopilot heading.
Disengaging the autopilot (Standby mode)
To return to hand steering:
1. Press
standby.
2. Remove the pushrod from the tiller pin to return to hand steering: the display
will show a flashing ‘C’ and the boat’s current compass heading.
3. The last heading is memorized and can be recalled (see
page 10
).
D354-2
D353-2
81130_5.book Page 8 Wednesday, June 15, 2005 3:48 PM
To Next Page
Loading...
