Raymarine St290 - Pods

6-2-4 Section 6: Installation
ST290 Instrument System Owner’s Handbook
Figure 2-2: Running SeaTalk and SeaTALK
2
cables
Pods
Each transducer Pod is supplied with a fitted SeaTALK
2
cable and
integral plug. The recommended method for installing the Pods is to fit
them in close proximity to one another and plug the cable from each Pod
to a 5-way SeaTALK
2
connector block (as in Figure 2-2 ).The connector
block is connected to SeaTALK
2
and also provides a convenient point to
insert a SeaTALK
2
terminator.
SPEED
25.
68
KNOTS
SPEED
25.
68
KNOTS
SPEED
25.
68
KNOTS
Plug Terminator
into instrument
spare connector
D6011-2
SeaTALK
2
SeaTALK
2
SeaTalk
Data Processing Unit
If appropriate, connect
to existing SeaTalk bus,
or Raymarine plotter,
GPS navigator or radar
connects to ST290 analog instruments,
keypads & Smart Heading System
connects to ST290 digital instruments
and transducer Pods
Heading information
from Smart Heading
System
ST290
Terminator
connects to ST290 digital instruments
5-way connector 5-way connector
RF ground
ST290
grounding cable
81183_2 S6.book Page 4 Wednesday, May 7, 2003 11:27 AM