Chapter 2: Setting Up Graphic Displays 7-2-19
ST290 Instrument System Owner’s Handbook
Figure 2-21: Transducer calibration overview (Graphic Display)
Starting calibration
The calibration procedures are accessed via pages in the Transducer
Calibration chapter, and are described here in the order in which they are
selected. To carry out transducer calibration:
1. In User Setup, select the TRANSDUCER CALIBRATION chapter.
2. Press the button to move to the calibration procedure you want to
carry out (see Figure 2-21 ).
D5966-1
Momentary Hold down
COMPASS CALIBRATION WIND VANE CALIBRATION
SPEED CALIBRATION
DEPTH OFFSET
GENERAL OFFSETS
To PILOT setup chapters
SWING COMPASS
ALIGN HEADING
VARIATION
SWING VANE
ALIGN VANE
From DISPLAY OPTIONS
setup chapter
81183_2 S7.book Page 19 Wednesday, May 7, 2003 1:52 PM
To Next Page
Loading...
