Chapter 2: Autopilot Operation 8-2-3
ST290 Instrument System Owner’s Handbook
Pop-up message modes
Alarm and Information messages
Autopilot alarms, information and temporary setting changes are
displayed using “ pop-up” style messages. These messages appear in
front of the current display (single-, dual or quad-element screen) and
indicate a button with an associated action. On taking an action, the
display returns to the normal operating mode.
.
Figure 2-3: Pop-up alarm message
Pop-up pilot mode
Autopilot mode or course changes can also be displayed in a “ pop-up”
window (see Figure 2-4 ). You can enable or disable this feature as
described in the Graphic Display User Setup procedure (see Section 7,
System Setup).
.
Figure 2-4: Pop-up pilot mode
Example pop-up alarm message:
This shows an autopilot off course alarm
and silence action button, in a pop-up
window, over a quad-element page.
Example pop-up course-change
message:
This example shows a new locked
heading, following a commanded
course change in AUTO mode.
The pop-up is displayed for 4 seconds.
D6048-1
D6050-1
81183_2 S8.book Page 3 Tuesday, May 6, 2003 9:08 AM
To Next Page
Loading...
