46 ST3000 Wheel Drive Autopilot - Owner’s Handbook
4 Installing the Wheel Pilot
4. When you have determined the correct position for the clevis,
carefully draw around its base.
5. Remove the drive unit and draw around the inside of the
elongated fixing holes on the clevis.
6. Drill two 8 mm (
5
/
16
in) clearance holes for the clevis fixing bolts
at the lower end of each elongated hole position. This allows the
belt to be subsequently tightened if necessary.
Note: Before drilling the holes, check that you have access to the
other side of the mounting wall to attach the nuts!
D5639-1
D5640-1
D5653-1
81194_1.book Page 46 Wednesday, July 25, 2001 12:10 PM
To Next Page
Loading...
