Raymarine ST40 - Chapter 3. Rotavecta Wind Transducer; Disassembly;Reassembly

Chapter 3, Rotavecta Wind Transducer
ST40 Instruments Service Manual 83149-2 3-7
Rotavecta Wind
Transducer
Chapter 3. Rotavecta Wind Transducer
Disassembly/reassembly
1. Allen grubscrew M3
2. Rotavecta cups
3. Captive nut
4. Rotavecta pod
5. Pod 'O' ring
6. Rotavecta body
7. Mounting pod screw M5 (x2)
8. Base plate
9. Base plate locknut
10. Cover plate
11. Connecting cable
12. Mounting pod cover plate
13. Mounting pod
14. Grubscrew M5
1 (Note A)
2
3 (Note A)
6
7
8
9
10
12
13
14
11
Note:
If the Allen grubsrew (1) is backed off too far,
the captive nut (3) can fall out. When disassembling,
unscrew the grubsrew just sufficiently to allow the
Rotavecta cups (2) to be pulled from the shaft.
4
5
D4046-3
Rotavecta Wind Transducer Exploded View