12 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
ïSubsequent presses of the disp key cycles the possible illumination
settings: L3, L2, L1, OFF, L1 , L2 , L3 etc. where L3 is the brightest
setting.
The display times out to normal operation after 7 seconds of keypad
inactivity.
Pressing any other key before the 7 second time-out will select the
mode assigned to that key (for example, auto selects Auto mode,
st a ndby selects Standby mode).
Notes: If other SeaTalk instruments or autopilot control units are
connected to SeaTalk, the illumination can be adjusted from these
units.
Any adjustments to the illumination are lost when the unit is
switched off.
The keys are still lit at a courtesy level when the display lighting is off.
2.5 Data pages
The disp key is used to cycle ìpagesî of SeaTalk or NMEA data. Once
a Data Page is selected, this page becomes the principle autopilot
display. The autopilot mode displays (Standby, Auto, Track and Vane)
then become ìpop-upsî, and are displayed for
5 seconds when the autopilot mode is changed or a course change is
made.
ïPress disp to display each Data Page in turn.
ïWhen the last Data Page is cycled, the display returns to the current
autopilot mode display (for example, Standby).
ïTo return to a previous Data Page, press disp for 1 second within 2
seconds of displaying a page. You can continue to move backwards
through the Data Page sequence in this way.
Up to 7 Data Pages are available using the disp key. The number of
pages, and the information displayed on each page, depends on the the
selections made in User Setup (see section 5.1).
The following illustration shows the default settings for the Data Pages.
To Next Page
Loading...
