Raymarine ST60 Compass Instrument - Variation Setting

Chapter 4: Calibration 29
Variation setting
A positive value indicates easterly and a negative value westerly. If the variation
has not been set, or the data is not available, the digital display shows a series of
dashes.
Changes to variation must be accepted before a TRUE heading can be selected,
(see
True/magnetic selection below ) .
If the ST60 Compass instrument is connected to SeaTalk and a value for variation
is present on SeaTalk (e.g. from an autopilot), this is accepted as the value for the
instrument. If a value is not present on SeaTalk, or if the instrument is not
connected to SeaTalk, use the
< and > keys to set the appropriate value.
D4391-1
User Calibration
Press either
or
Hold down
and
for approximately 2 seconds
CAL
TRUE
MAG
Calibration
Entry Screen
Linearisation
Heading
alignment
CAL
TRUE
MAG
CAL
TRUE
MAG
TRUE
MAG
CAL
TRUE
MAG
Lock Mode
Variation
Setting
True/Magnetic
Selection
to set the required values
CAL
TRUE
MAG
disp
lock
disp
disp
disp
disp
disp
disp