Raymarine ST60 Tridata Instrument - Depth; Current Depth Display

2 ST60 Tridata Instrument Owner’s Manual
•Using the trip key to gain access to log, trip, water temperature and timer
information.
All key presses are momentary unless otherwise stated.
Depth
Use the depth key to select the required information, as shown in the Using the
depth key
illustration. The depth measurement units are either feet or metres, as
selected during user calibration (see
Chapter 4, Calibration ).
Current depth display
The current depth screen shows the title DEPTH, the selected depth units and the
depth measurement. It also shows a depth trend indicator, which is either an up
arrow to show seabed rising or a down arrow to show seabed falling.
If for any reason depth information is lost, the DEPTH title will flash once per
second and the displayed depth value will be the last good reading.
Current depth
Shallow
alarm threshold
Deep
alarm threshold
Anchor shallow
alarm threshold
Anchor deep
alarm threshold
depth
depth
depth
depth
Using the depth key
D4413-1
depth
reset
reset
reset
To enter and exit alarm adjust mode
In adjust mode, use
To enable/disable any alarm
trip
trip
Press
for 2 seconds
(toggle action)
Press
and together
to decrease or
to increase
81040_5.book Page 2 Monday, February 20, 2006 2:39 PM