Chapter 3: Installation 13
Chapter 3: Installation
This chapter describes how to install the ST60 Tridata instrument, and associated
Speed and Depth transducers. The transducers are fitted in the hull of the vessel
and connected to the rear of the instrument. The actual type of transducers
depends on the type of hull in which they are to be installed.
For advice, or further information regarding the installation of this equipment,
please contact the Raymarine Product Support Department or your own
National Distributor.
3.1 Planning your installation
Before starting the installation, spend some time considering the best positions
for both transducer and instrument, such that the
Site Requirements
and the
EMC
Guidelines
(below) are satisfied.
Site requirements
Transducers
The transducer types required for the various hull types are as follows:
D4447-4
Speed
14 mm
(0.57 in)
100 mm
(3.95 in)
75 mm (2.94 in)
diameter
51 mm (2.0 in)
diameter
75 mm (2.94 in)
diameter
75 mm (2.94 in)
diameter
5 mm
(0.19 in)
Depth
75 mm (2.94 in)
diameter
51 mm (2.0 in)
diameter
95 mm (3.75 in)
81040_5.book Page 13 Monday, February 20, 2006 2:39 PM
To Next Page
Loading...
