Chapter 3: Installation 19
2. Apply the surface mount template (supplied at the rear of this handbook)
to the selected location and mark the centres for the fixing studs (1) and
the aperture (3) that will take the rear casing of the instrument.
3. Drill out the two 5 mm fixing stud clearance holes (2).
4. Cut out the clearance hole (3) then remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then stick
the gasket into position on the rear of the instrument.
6. Screw the two fixing studs into the threaded sockets on the rear of the
instrument.
7. Mount the assembled instrument, studs, bezel and gasket into the panel.
Secure from behind with the thumb nuts (5).
Flush mounting
The Flush Mounting Kit uses a low-profile bezel to reduce the fitted profile of the
instrument, to approximately 6 mm above the panel fascia.
D4343-2
Surface mounting
11223455
81040_5.book Page 19 Monday, February 20, 2006 2:39 PM
To Next Page
Loading...
