Chapter 3: Installation 21
Flush mounting procedure
Flush mount your instrument (see the
Flush mounting
illustration) as follows:
1. Assemble the ST60 instrument and low-profile bezel as described under
Fit-
ting the low-profile bezel
.
2. Ensure that:
• The panel on which you intend to mount the instrument is between 3 mm
and 20 mm thickness.
• The selected location is clean, smooth and flat.
• There is sufficient space behind the selected location to accommodate the
rear of the instrument and connectors.
3. Apply the flush mount template (supplied at the rear of this handbook) to
the selected location and mark out the aperture into which the assembled
instrument and bezel will sit.
4. Cut out the aperture (3) for the assembled instrument and bezel and
remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then stick
the gasket into position on the rear of the bezel.
D4362-2
789
Fitting the low profile bezel
81040_5.book Page 21 Monday, February 20, 2006 2:39 PM
To Next Page
Loading...
