22 ST60 Tridata Instrument Owner’s Manual
6. Screw the two fixing studs (1) into the threaded sockets on the rear of the
instrument.
7. Mount the assembled instrument, studs, bezel and gasket into the panel.
8. Locate the flush mount bracket (6) onto the fixing studs and secure the
assembly to the panel with the thumb-nuts (5).
Bracket mounting
A Control Unit Mounting Bracket (Part No. E25009) enables you to mount your
ST60 instrument in locations where other forms of mounting are impractical.
Although this provides a useful alternative method for securing your instrument,
it is only suitable for use in positions where the instrument will not be exposed to
water.
To bracket mount your ST60 instrument, do so in accordance with the Control Unit
Mounting Bracket
Instruction Sheet
.
Fitting transducer
The ST60 Tridata instrument is supplied, with appropriate through-hull Speed and
Depth transducers.
Flush mounting
D5462-1
113
4
556
81040_5.book Page 22 Monday, February 20, 2006 2:39 PM
To Next Page
Loading...
