Calibration 41
Boat show mode
CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to OFF. If necessary, use the
trip or
reset key to achieve this.
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. If you want to apply the factory defaults, ensure the display shows YES, but
if you want to retain the values you have set up, ensure that the display shows NO.
Use the
trip and reset keys to make the required selection.
The values you have selected will be applied when you exit this screen.
Leaving Dealer calibration
Hold down the depth and speed keys for 2 seconds to save your settings, exit
Dealer calibration and resume normal operation.
81040_5.book Page 41 Monday, February 20, 2006 2:39 PM
To Next Page
Loading...
