Raymarine ST60 - Response Settings; User Calibration On;Off

10 ST60 Graphic Display Commissioning Guide
User calibration on/off
Press the track or reset button to toggle the User calibration either ON or
OFF as required.
Note: If at any time, you want to access the software version and serial num-
ber, you need to set User calibration ON.
Response settings
The response values determine the sensitivity of the display to data changes.
You can set each response value from 1 to 15. A low number provides a
smooth response and a high number a much livelier response.
Use the button to select the response you want to set, then use the track
(decrement) and reset (increment) buttons to set the required value.
D6479-1
for approximately 12 seconds
Dealer calibration
To enter Dealer calibration, hold down
and
User cal
on/off
Response Battery voltage
Default resetSelf test entry
Entry
screen
track
reset
track
reset
and
81228_1.book Page 10 Wednesday, November 19, 2003 10:29 AM