Chapter 2: Preparation for Use 11
You can set responses for the following data:
• Speed (
SPEED RESP.)
• Depth (DEPTH RESP.)
• Heading (
HEADING RESP.)
• Wind angle (
WIND ANGLE R.)
• Wind speed (WIND SPEED R.)
• Cross track error (
XTE RESP.)
Battery voltage
Use the BATTERY screen to set the voltage reading at the ST60 Graphic
Display to be the same as the actual supply voltage from the boat’s electrical
system.
WARNING:
High voltages can cause death or serious injury. Always take
appropriate precautions when working with electricity. Before
accessing the electrical system, ensure you know the location of high
voltage points and stay well clear of them.
To set the voltage reading at the ST60 Graphic Display:
1. With the BATTERY screen displayed, measure the 12 V supply voltage at
the battery.
2. At the ST60 Graphic Display, use the track or reset button to set the dis-
played voltage to the same value as the measured voltage.
Default reset
You can use this screen to reset the ST60 Graphic Display operating
parameters to the factory default values. If you want to apply the factory
defaults, ensure the display shows YES, but if you want to retain the current
values, ensure that the display shows NO.Usethetrack and reset buttons
to make the required selection.
If you have selected YES, the factory defaults will be applied when you exit
this screen.
The factory default values are as follows:
Parameter Factory default
Last display Speed
Heading Magnetic
Temperature units Degrees Celsius
81228_1.book Page 11 Wednesday, November 19, 2003 10:29 AM
To Next Page
Loading...
