Raymarine ST60 - Chapter 1: Operation; 1.2 Normal Operation

Chapter 1: Operation 1
Chapter 1: Operation
1.1 Introduction
This handbook describes how to operate, maintain and install the Raymarine
ST60 Multi instrument.
CAUTION: Calibration requirement
The ST60 Multi instrument is calibrated to factory (default)
settings when first supplied. To ensure optimum performance on
your boat, this product must be calibrated before use. Do NOT use
the product until it has been calibrated using the procedures in
Chapter 4, Calibration .
1.2 Normal operation
The information displayed on the ST60 Multi instrument is organized in groups or
‘chapters’, and within each chapter, the different types of information are
presented as pages. The availability of pages on your ST60 Multi instrument
depends on:
• What information is available from SeaTalk. This handbook assumes all data
sources are available.
• Which pages are enabled during
Instrument configuration (see Chapter 4,
Calibration
). This handbook assumes all pages are enabled.
Finding the information you want
The disposition of the ST60 Multi chapters and pages, is shown in the Chapter
selection and content
illustration, below. This illustration assumes a system
where all information sources are available.
81039_4.book Page 1 Wednesday, March 24, 2004 3:14 PM