Raymarine ST60 - 1.5 Alarms

Chapter 1: Operation 7
Autopilot chapter pages
1.4 Using the track key
If your system includes a SeaTalk autopilot working in conjunction with a track
plotter, you can operate the track plotter in track mode, as follows:
1. Press the
track key once, so the track plotter enters track mode.
2. In track mode to plot a track to the next waypoint, press the
track key for
1second.
3. To leave track mode, press the
track key again.
1.5 Alarms
Internal alarms
The ST60 Multi instrument responds to alarm signals by sounding an internal
buzzer and by flashing the appropriate alarm message at the top of the screen
alternately with the normal top line of the current display. The alarm messages are
as follows:
Function Title Remarks
Pilot status - Same function as pop up pilot display, but does not time out.
Rudder angle RUDDER In degrees either P(ort) or S(tarboard).
Message Meaning
SHALLOW Shallow water. See
Note below.
DEEP ALM Deep water. See Note below.
ANCHOR Deep or shallow anchor. See Note below.
WIND ALM Wind speed. See Note below.
LOW VOLT The power supply voltage has fallen below the low voltage
threshold
GUARD Radar alarm
MARPA Radar alarm
RAD FAIL Radar alarm
81039_4.book Page 7 Wednesday, March 24, 2004 3:14 PM