10 ST60 Multi Instrument Owner’s Handbook
Contrast
To adjust the display contrast:
1. Hold down the key for approximately two seconds, to enter the contrast-
adjust mode.
2. There are four preset contrast settings. Momentarily press the key to cycle
through these settings until you achieve optimum display quality.
3. Press any other key to leave the contrast-adjust mode.
Note:
The display will also return to normal operation 7 seconds after the last key press.
1.8 Pop-up Pilot
A Pop-up Pilot facility enables instruments connected to SeaTalk to constantly
monitor any changes to the autopilot mode and to the course settings. If one of
these parameters changes, the new value is immediately displayed on the ST60
instrument for 5 seconds, after which time the display reverts to the previous
display.
This facility can be enabled or disabled during User calibration (see
Chapter 4,
Calibration
).
1.9 Remote control
When it is connected to SeaTalk, the ST60 Multi instrument can be controlled
remotely with a SeaTalk Remote Keypad Unit. Remote control of an instrument is
indicated by a REMOTE legend on the display, to indicate that the keypad has
control.
Details on how to use the remote control facility can be found in the
SeaTalk
Remote Keypad Owner’s Handbook
.
81039_4.book Page 10 Wednesday, March 24, 2004 3:14 PM
To Next Page
Loading...
