18 ST60 Multi Instrument Owner’s Handbook
Each ST60 instrument is supplied with a standard bezel for surface mounting.
Optional mounting kits are available for flush mounting and bracket mounting
the instrument. If you have ordered the flush mounting option a low-profile bezel
and four fixing screws are also provided.
Fitting the instrument
The ST60 Multi instrument can be installed using one of a number of different
mounting options:
• Surface mounting. Gives a profile of approximately 0.95 in (24 mm).
• Flush mounting. Gives a profile of approximately 0.25 in (6 mm).
• Bracket mounting.
The ST60 instruments can also be mounted behind a panel with just the
instrument dial and keys visible.
Surface mounting
To surface mount your ST60 instrument (see the
Surface mounting
illustration):
1. Ensure that:
• The selected location is clean, smooth and flat.
• There is sufficient space behind the selected location to accommodate the
rear of the instrument and connectors.
D4340-2
Surface mounting
11223455
81039_4.book Page 18 Wednesday, March 24, 2004 3:14 PM
To Next Page
Loading...
