Raymarine ST60 - Page 36

24 ST60 Multi Instrument Owner’s Handbook
Use crimped spade terminals to connect to the NMEA connectors. In order to
ensure a secure connection when fitting spade connectors, prepare the cable as at
(a) in the following illustration, then fold back the wire strands and insert into the
spade connector as at (b). Ensure the wire strands do not extend beyond the rear
of the spade connector insulation, then crimp the connector to the wire.
D4404_2
N
M
E
A
I
N
N
M
E
A
O
U
T
NMEA in
Connections to ST60 Multi instrument
Either NMEA out
or
Auxiliary Alarm Buzzer
Note:
instrument must be set up for either NMEA or Anciliary Alarm Buzzer
operation, in accordance with the instructions in
Chapter 4, Calibration.
If connections are made to the NMEA OUT terminals, the
SeaTalk cable
SeaTalk cable
Blue
Red
Blue
Red
3 mm
6 mm
50 mm
(a)
(b)
D4467-7
81039_4.book Page 24 Wednesday, March 24, 2004 3:14 PM