Raymarine ST70 - Setting Date Format; Setting Time Format

Chapter 2: Commissioning Procedures 9
If you want to accept the Time & Date values:
1. Select the
Continue option (if necessary use <
or >).
2. Press ENTER to proceed to the Units summary
page.
3. Proceed from Data units (below).
If you want to change any Time & Date values, carry
out the Setting date format, Setting time format
and/or Setting local time procedure below, as
appropriate.
Setting date format
To set the required date format:
1. At the
Time & Date setup menu, use < and > to
select the
Set date format option, then press
ENTER , to display the Set date format page.
2. Use
< and > to select the required Date Format,
then press
ENTER , to save the format and
return to the
Time & Date summary page.
3. Press
ENTER to select the Time & Date setup
menu.
Setting time format
To set the required time format:
1. With the
Time & Date setup menu displayed,
use
< and > to select the Time Format option,
then press
ENTER , to display the Set time
format
page.
2. Use
< and > to select the required Time Format,
then press
ENTER , to save the format and
return to the
Time & Date summary page.
3. Press
ENTER to select the Time & Date setup
menu.
D9982-1
Press ENTER to select
Time & Date
Continue
D9544-1
Press ENTER to select
Time & Date
Set date format
D9542-1
i
i
Press ENTER to accept
Set date format
dd/mm/yy
< & > to adjust.
CANCEL exits without saving.
D10362-1
Time & Date
Set time format
Press ENTER to select
D9779-1
12-hour
Press ENTER to accept
Set time format
i
Use < & >to adjust.
CANCEL exits without saving.
81284_1.book Page 9 Friday, May 4, 2007 7:29 AM