Chapter 2: Commissioning Procedures 11
Check the information on the
Units
summary
pages.
With the second
Units
summary page displayed, press
ENTER
to display the
Units
setup menu.
If you want to accept all data
Units
as currently set:
1. Select the
Continue
option (if necessary use <
or >).
2. Press
ENTER
, to leave Initial Setup and
proceed to the first operational page.
3. Proceed from Depth offset (below).
If you want to change any data
Units
:
1. With the
Units
setup menu displayed, use
<
and
>
to select the type of data you want to change,
i.e. Speed, Depth, Distance etc.
2. Press
ENTER
, to display the setup page for the
units you have selected.
3. Use
<
and
>
to select the required units
4. Press
ENTER
, to save the units setting and
return to the first
Units
summary page.
5. Press
ENTER
twice to display the
Units
setup
menu
6. If you want to change any other units, repeat
steps 1 to 5 of this procedure.
Leaving units setup
When all units are set to what you want, display the
Units
setup menu, then:
1. Use
<
and
>
to select the
Continue
option.
2. Press
ENTER
, to leave Initial Setup and proceed to the first operational page.
Depth offset
Depths are measured from the Depth transducer to the sea bed, but you can apply an
offset value to the depth data, so that the displayed depth reading represents the
depth to the sea bed from either the keel or the water line.
If an offset is not applied, the displayed depth readings are from the transducer to the
sea bed.
D
9
980
-1
Press ENTER to select
Units
Continue
D9441-1
Press ENTER to select
Units
Wind Speed Units
D
9
4
4
2
-1
i
i
Press ENTER to accept
Wind Speed Units
KTS
Use < & > to adjust.
CANCEL exits without saving.
81284_1.book Page 11 Friday, May 4, 2007 7:29 AM
To Next Page
Loading...
