25
Chapter 3: Setup Procedures
3.1 Introduction
Many operating parameters are set during commissioning and may not need to be
changed again. However, if any of these parameters are not as you want them, you
can change
• The method of ground wind calculation. Refer to Chapter 2: Commissioning Pro-
cedures.
• The magnetic variation. Refer to Chapter 2: Commissioning Procedures.
• The response rate of an instrument. Refer to Chapter 2: Commissioning Proce-
dures.
• The language or vessel type. See below.
• The time/date format. See below.
• The local time. See below.
Other setup procedures likely to be useful on a day-to-day basis are given in your
ST70 Instrument Operating Guide. These procedures include:
• Changing the screen brightness level.
• Changing the screen colors.
• Changing data units.
• Switching off pages on and off, and/or changing page layout and content.
• Setting local time.
• Using the alarm clock.
3.2 Procedures
Changing the language or vessel type setting
If you need to change the language or vessel type, use the following procedure:
1. Press
MENU
to display the
Main Menu
then use
<
or
>
to scroll to
Advanced Options
.
2. Press
ENTER
to display the
Advanced Options
menu.
3. Follow the Setting Language or Setting Vessel
Type procedure (below), as appropriate.
Setting Language
1. At the
Advanced Options
menu, use
<
and
>
to
select
Language
, then press
ENTER
to display
the
Language
menu.
2. Use
<
and
>
to select the language you want,
then press
ENTER
to save and exit the menu.
3. Use the Leaving Advanced Options procedure
below, to return to the operational page.
D9300-1
Press ENTER to select
Main Menu
Advanced Options
D9342-1
Press ENTER to select
Language
English (UK)
81284_1.book Page 25 Friday, May 4, 2007 7:29 AM
To Next Page
Loading...
