H56874 4/03 www.tycothermal.com +1 (650) 474-7400 32
UPDATE NETWORK
Use this command to update the TraceTek network when TTDM, TTSIM or TT-NRM
units have been added or deleted and assigned unique addresses. When activated, the
command immediately searches all possible addresses to determine what equipment
has been connected. The current event status of all devices will be maintained by this
command.
Note: Use the INIT NETWORK command to reset all current event status information.
► Select SIM Network and press ENTER.
► Select Update Network and press ENTER.
INIT NETWORK
Use this command to initialize the TraceTek network once all TTDM, TTSIM and TT-
NRM units have been connected and assigned unique addresses. When activated, the
Init Network command immediately searches all possible addresses to determine what
equipment has been connected. The current event status of all devices will be reset by
this command.
NOTE: Use the Update Network command to update an existing network without resetting
the status of existing SIM’s.
► Select SIM Network and press ENTER.
► Select Init Network and press ENTER.
To Next Page
Loading...
