Need help?Do you have a question about the RAZBAM Metroliner III SA227-BC and is the answer not in the manual?
Details the various gauges related to engine monitoring and performance.
Details the airspeed indicator, its scales, and operational speed limits.
Details the DC power system, including generators, batteries, and GPU.
Explains the master warning system, annunciator panel, and light indications.
Details the EGT gauge, its units, and maximum operational limits.
Describes the engine torque gauge, its range, and maximum continuous rating.
Explains the engine RPM gauge calibration and meaning.
Details the fuel flow indicator calibrated in pounds per hour.
Describes the engine oil pressure gauge in PSI.
Explains the fuel quantity gauge calibrated in hundreds of pounds.
Details the engine oil temperature gauge in degrees Celsius.
Indicates fuel level on each wing tank.
Describes the fuel pressure gauge in PSI.
Explains the fuel control unit with governors and manual metering.
Explains propeller feathering to minimize drag in case of engine failure.
Explains the operation of the power levers on the center pedestal.
Details the operation of the speed levers for RPM control.
Provides the step-by-step procedure for an automatic engine ground start.
Details the controls for the CAWI system, including switches and test functions.
Explains the engine fire detection system and warning lights.
Details the activation of the fire extinguisher bottles for engine fires.
Explains how to control the landing gear using the center console lever.
Explains the operation and functions of the VHF radio units.
Explains the pilot's EHSI display and its control panel.
Explains the copilot's EHSI display and its control panel.
Illustrates the EHSI display layout and its various data areas.
Explains the operation of the TCAS system, including range and mode settings.
Explains how to power on and initiate the GPS self-test.
Explains how to activate basic autopilot functions like Yaw Damper.
Details how to engage and control altitude hold using the selector.
Explains how to engage heading hold via EHSI control panel or keyboard.
Lists and describes the buttons on the 2D autopilot control panel.
Lists the cockpit, console, and panel checks before engine start.
Provides the procedure for starting the aircraft engines using battery power.
Details the engine start sequence for the right engine.
To Next Page
General