Razer Naga - First Time Calibration Process

22 | For gamers by gamers™
First Time Calibration
If you are calibrating your Razer Naga for the first time, you will be required to perform
a manual tuning via the Razer Synapse interface to initialize your mouse for all Razer
mouse mats. This is only required once unless the mouse has been reset to factory
default configuration. Click CALIBRATE to begin the process.
Manual tuning requires that you move your mouse slowly along the mouse mat for at
least 3 seconds. At any point during this process, you should not:
 Reposition the mouse
 Lift the mouse off the mouse mat
 Stop moving the mouse
Click CALIBRATE to begin the process.