DIRT QUAD BATTERY
INSTALLATION INSTRUCTION
WARNING: Turn off the main power switch before proceeding with the following instructions.
Step 1:
Use the rear carry handle to carefully lift Dirt Quad
up on front end. Using a 5mm allen wrench,
remove the 4 bolts on the bottom of the battery
cover. Using a 3mm allen wrench, remove the 2
bolts on the support bracket (Figure 1). Using the
rear carry handle, slowly lower the Dirt Quad back
down to the ground. Save bolts for reassembly.
Using a 6mm allen wrench, remove the 4 bolts
on the handlebar clamps and detach handle-
bars. (Figure 2)
Step 2:
Need Help? Visit our website for additional instructions at www.razor.com or call toll-free at 866-467-2967 Monday - Friday
8:00am - 5:00pm Pacific Time.
1
Tools Needed: A. 3mm Allen Wrench
B. 4mm Allen Wrench
C. 5mm Allen Wrench
D. 6mm Allen Wrench
E. No. 10 Open Wrench
F. Phillips Head Screw Driver
Figure 1 Figure 2
Step 3:
Using a 5mm allen wrench, remove the 4 bolts
on both sides of the footrest platforms. (Figure 3)
Using a # 10 open wrench, remove the 2 bolts
underneath the rear fender. (Figure 4)
Step 4:
Figure 3 Figure 4
3mm Allen
5mm Allen
To Next Page
Need help?
General