9
2 Using two 19 mm wrenches,
loosen both axle nuts.
5 Reattach the chain guard. Test
ride and check. Readjust as needed.
3 Push the chain tensioner down
to loosen the chain and remove the
chain from the wheel sprocket and
motor sprocket. Push and remove the
wheel downward.
Note: Your hands will get greasy
doing this.
1 Loosen screws and remove chain
guard.
4 Install the new chain or wheel
by slipping the chain around the
axle. Slide the axle into the slots on
the frame. Slide the chain tensioner
down and maneuver the chain onto
the rear sprocket and motor sprocket.
Replacing the Chain and Tire
Tools required: Phillips screwdriver and two (2) 19 mm wrenches.
Note: the arrangement of the
hardware sequence:
Right Side (Throttle)
16-1 Nut
16-2 Washer
Frame
16-3 Spacer
Left Side (Brake)
16-1 Nut
16-2 Washer
Frame
16-3 Spacer
16-1
16-3
16-2
16-2
16-3
16-1
REPAIR AND MAINTENANCE
To Next Page
Loading...
