2
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
E100
MOTOR REPLACEMENT
INSTRUCTIONS
PA R T# W13111612 0 3 0
Using a Phillips screwdriver, remove the three (3)
screws that hold the motor to the frame (circled in the
image below).
Step 6
Using a Phillips screwdriver, remove the two (2)
screws on the chain guard (circled in the image
below) and remove the chain guard and set aside.
Using a Phillips screwdriver, remove the two (2)
screws from the battery holder (circled in the image
below). Remove the deck cover and batteries from the
tray and set aside.
Step 5
Step 4
This step is for the E100 Glow ONLY, disconnect the
deck lights connector from the controller.
Step 3
To Next Page
Loading...
