5
REPAIR AND MAINTENANCE
1 Use the special valve
extender/adapter supplied.
The valve adapter is located
in the bag with the owners
manual supplied at the time
of purchase.
2 Align the access hole in
the drive sprocket with the
tire valve. Thread the adapter
completely onto the valve and
attach the pump. Inflate to
the PSI indicated on the tire
sidewall.
3 Remove valve adapter
immediately after inflating.
q Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of
manufacturing and
your purchase.
E150 / E200 / E300 Rear Tire
1 Using a bicycle style tire
pump equipped for a Schrader-
type valve, inflate the front
tire to the PSI indicated on the
sidewall of the tire.
E150 / E200 / E300 Front Tire and E100 Tires
WARNING: Failure
to remove the valve adapter
after inflating will cause the
inner tube and/or adapter to
be severed by the rear drive
sprocket.
Note: If you lose the adapter,
a valve stem extender can be
purchased at almost any auto
parts store.
Note: The pressurized air
supplies found at gasoline
stations are designed to inflate
high-volume automobile tires.
If you decide to use such an air
supply to inflate your electric
scooter tires, first make sure
the pressure gauge is working,
then use very short bursts to
inflate to the correct PSI. If you
inadvertently over-inflate the
tire, release the excess pressure
immediately.
To Next Page
Loading...
Need help?
General
