To activate the lights, unscrew the light from the cap base and insert three (3) AG10 Alkaline button cell
batteries (included) positive side down and re-attach the light to the cap base.
Remove existing valve stem cap from wheel and replace with light-up valve stem cap.
To replace the batteries, follow the same steps mentioned above. Discard old batteries in a responsible manner.
6
Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and
your purchase.
Using a bicycle tire pump equipped
for a Schrader valve, inflate the tires
to the PSI indicated on the sidewall
of the tires.
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate your
Pocket Mod tires, first make sure
the pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
over-inflate the tires, release the
excess pressure immediately.
ASSEMBLY AND SET-UP
Light-up Valve Stem Caps (select products only)
WARNING:
• Alkaline batteries included. Adult
supervision needed for installation
and disposing of batteries.
• Batteries should only be
replaced by an adult.
• Loose batteries could present
a choking hazard and should be
kept away from small children.
• Dispose of batteries properly.
• DO NOT mix old and new
batteries and DO NOT mix
alkaline, standard (carbon-zinc)
or rechargeable (ni-cad, ni-mh,
etc.) batteries.
Note: Make sure to install ALL THREE
(3) batteries positive (+) side down.
The lights are motion activated and
will only turn on when the product
is in motion.
Alkaline batteries are not
covered under the warranty.
To Next Page
Loading...
Need help?
General
