The inputs of this mixer are the Ail and Ele sticks, plus the virtual channel selected in "Collective source". This
channel would see entries added on the MIXER page for one or more pitch curves.
The outputs of the CCPM mixer are CYC1, CYC2 and CYC3, which need to be assigned on the MIXER page to
the channels you will connect your servos to.
Note that the settings made here have no effect unless you are using those CYC1, CYC2 and CYC3 sources. A
multirotor or flybarless helicopter which uses onboard computers/mixers will NOT use them.
Flight modes
Next up is the flight modes screen.
8 flight modes plus the default one are available for use. Each of them can be named, has a selectable activation
switch (physical or logical), a trim selection array (R, E, T, A when shown means the mode has its own trim setting
for that control, but each can be changed to a number from 0 to 9 and thus use the same value as the specified
mode), and slow up/down parameters for smooth transitions between modes.
The priority of the flight modes is such as the first FM of 1-8 that has its switch ON is the active one. When none
has its switch ON, the default FM0 is active.
Inputs
The next screen allows setting one or more input formatting rules to each stick axis. This is the first step of the
control chain - where you define the amount of control authority you want on each stick.
17
To Next Page
Loading...