Inserting Batteries in the Remote
Remote Control Reception Angle
• Remove the cover of battery cabin on the back of the remote control by pushing the tab and sliding the cover.
• I
nsert two AAA batteries, making sure the polarities (+ and -) are aligned correctly.
• P
lace the cover back.
• A
re the polarities (+, -) correct?
• A
re the batteries worn out?
• I
s there an AC power failure?
• I
s the power cord plugged in?
• I
s there any interference or block near the remote
control sensor?
Use your remote control within the distance and angle range shown below.
If the remote control does not work, check these points:
• U
sed batteries should be recycled.
• K
eep out of children’s reach.
• D
O NOT use new and old batteries together.
• C
hange both the batteries at the same time.
• W
hen not using the remote control for a long time,
remove the batteries from the unit.
CAUTION:
7 meters
Remote Control Instructions
18
Universal Remote Control Code List
For Universal Remote Control brands listed
below, please use accompanying codes and
refer to your Universal Remote ControlUser
Manual for basic Instruction for changing TV
code to operate the TV model.
Codes for DIRECTV: 0178, 10178
Codes for Time Warner Cable: 0178, 10178
Codes for Cox Communications: 0178
Codes for Comcast: 10178
Codes for Dish Network: 627
Codes for Fios Verizon: 0205, 0057, 0493, 0775
To Next Page
Loading...
