Using Your TV and Remote
With VCRs: Setting the VCR1 Channel
9
The VCR 1 Channel works with VCR on the remote. If the VCR 1 Channel
is set, pressing VCR selects the channel to see the VCR picture. The VCR 1
Channel setting depends on which diagram you have used from the
Connection Guide. If you want to turn this feature off, set the VCR 1
Channel to Disable. Refer to the chart below for your setting.
A.Press TV to set the remote to
control the TV.
B. Press MENU•PROG to select the
Setup menu. This menu is
white.
A.Press MOVE H (down) to
highlight the VCR 1 Channel.
B. Press E to highlight the channel.
A.Enter channel 00, 03, or 04.
Choose your setting from the
chart below. Press CHANNEL
down until “Disabled” is
displayed to turn the feature off.
1. Select the Setup Menu
2. Highlight VCR1 Channel
3. Enter channel number
13
Controls Alarm Adjust Setup
English
Français Español
Autoprogram
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
English
Français Español
Autoprogram
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
English
Français Español
Autoprogram
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
Diagram used from the
Connection Guide:
1B, 1C, 2B, 2C, 3B, 3C, 4C, 5C
4B, 5B
Set VCR1 Channel to:
00
3 or 4 (same as 3/4 switch)
VCR 1 Channel: 03
VCR 1 Channel: 00