,,~,
..
.
Follow the
Y
ons below if your range has the
.
cbck and
r shown at the right.
Youhave the qhoice of having the timershow the
f
time counting own or the time of day. In either case,
the timer will ignal at the end of the timer period to
;EzEl[g
SH TIME
alert
you that the time is up.
(Appearance IIMy
VW)
To Set the (10ck
NOTE: When you first plug in the range or after a
powerfailure, he entire Clock/Timer display will
light up.
1. Press the CI+OCKpad.
2. Press and ~ld the UP or DOWN pad and the time
!
of day will hange 10 minutes at a time. To change
the time by ingle minutes, give the pads short taps.
3. Press the C~K pad to start the clock.
To Set the Timer
1. Pressthe TIMERON/OFF pad.
2. Use the UP and DOWN pads to set the timer.
Short taps on the UP or DOWN pad change the
timer’s setting one minute at a time. Pressing and
continuing to hold the UP pad increases the setting
ten minutes at a time.
3. Once you have set your timer, press the TXMER
ON/OFF pad to start timing.
As the timer counts dowq a signal will indicate when
one minute is left. After this signal, the display will
count down in seconds.
Whentime runs OUGa final
signal will sound. Press the TIMER ON/OFF pad to
stop the signal.
To Change pr Cancel the Timer Setting
When the time! is counting down, use the UP and
DOWN pad to Ichangethe remainin
g time, or press
the TIMER 01’+VOFFpad to stop the timer. The timer
cannot be canc~lled unless you have fully completed
“set timer” ins@wtions above.
To Display #heClock While the Timer Is Operating
Pressing the C\OCK pad while the timer is operating
will not interf~e with the timer’s operation; the
display will ch ge to show the clock, but the timer
will continue
r
count down and will
still signal when
time is up. Pn+s the TIMER ON/OFF pad again to
change the display back to show the timer.
To Next Page
Loading...